.








Scan this QR Code
using your smartphone.
Bookmark us on your mobile device.
Take us everywhere!

Browse Categories

Supplies needed for the Nail Tip Fusion system:

It will usually take about an average of 200 I tipped strands for volume and length, and it will usually take about an average of 100 I tipped strands for volume.

Rat Tail Comb for clean sectioning
Gripper clips to section off hair cleanly
Your choice of Fusion Iron
Nail tipped hair-match to mid-shaft of client's natural hair
Bonding Guard Disc to protect and separate cleanly natural hair from bond during installation
 Orange Oil solvent for removal

 Do not cut blunt line into hair prior to installation of whatever system you use
If hair is cut blunt or if the natural hair has a heavy line, you should shatter or texturize the heavy line so that the new hair to be installed will blend easier and you will remove the blunt line


Prepare client’s hair for installation by using a de-toxifying or clarifying shampoo making sure no conditioner or any other product is used aster rinsing.
 
Sectioning
(1)  To determine where the partings will start take a comb and place it at the top back of the head.  Where the comb leaves the head is where the parting will start.
(2)  Make a parting from that point to the top back of the ear.
(3)  Determine where you want your first track to go. The first row is usually from the back of the middle of the ear all the way across to the back of the middle of the ear.
(4)  There are many invariable in installing the strands.  If the hair is thin and shorter you may want to "pack them in" the first 2-3 rows; this describes installing the extensions right next to each other across the row and section the next row right above the previous row leaving no hair out of the extensions.
(5)  After establishing weight for the first 2-3 rows, you can now "brick row" the extensions; this described installing the extensions on every other piece of hair and on the next row above the row you've just installed you will install an extension above an strand there there is an empty space with no extension installed there.  The effect will be like a checker board; every other strand will be installed above every other but moved over by one space.
(6)  Continue up the head until you reach the top leaving enough hair at the top to cover the last row of extensions.
Now that you are finished with the back you can start work on the sides in front.
Make sure all the rows follow the curve of the head. 
You will install about 3-4 rows of "packed in" extensions on the sides in front making sure you do not go all the way up to the hairline.
Start the first row in the front side just above the corner of the eye matching it up to the corner of a track coming from the back.

Instilling the Nail tipped extension

Section off about 1/4 inch piece of hair and tuck it into a guard disc
Slide Nail tip hair strand under the natural hair

Slide Nail tip and natural hair into the fusion Iron and hold until sufficiently heated


Roll in between fingers (finger guards may also be used to protect fingers and so bond does not stick to skin and any oils from the skin will not affect installation)

Hair extension is now installed making sure it is not installed to close to the scalp and hanging freely down from the natural growth
Removal 

 Heat bond with fusion iron and slip hair extension down off of natural hair
 
Drop orange oil Solvent onto any remaining bond

 Comb out any remaining bond, shampoo hair with clarifying shampoo
 

Shopping Cart
Your cart is empty.




Search

About Us |Contact Us |Policies | Sitemap | My Account 

© Hair Laboratories™  all rights reserved